Moisture Bloom Eliminator

For removal of white marks that have been caused by heat and water, from cellulose and pre-catalysed lacquered surfaces.

£17.99

7 in stock

Additional information

Weight 415 g
Dimensions 7 × 7 × 21 cm
gtin

B01JZXBRRW

Unit of sale

1

Part Number

21000

Product Information

Konig Moisture and Bloom Remover for removal of white marks that have been caused by heat and water, from cellulose and pre-catalysed lacquered surfaces.

For use on all acrylic and nitrocellulose based lacquers. It is a fast acting and fast drying product. For best results, leave overnight. It works by softening the existing lacquer and drying to a perfect finish and can remove slight surface scratches on tables and cabinets.

  • It is not necessary to shake the can.
  • Do not use at room temperatures below 20°C – important for a new optimum formation of the lacquer coat. Nor process at a humidity exceeding 70%, as otherwise surface will
    turn ‘white’.
  • Check compatibility on an inconspicuous area, first. Apply a wet and even lacquer coat. With vertical surfaces, spray on several thin layers to avoid a ‘flowing off’ of the solvent.
  • Prior to application make sure area to be treated is clean, as residues like grease, maintenance products, nicotine layers etc. will react as a barrier coat, preventing solvents from reacting or making them react irregularly or even allowing soilings to penetrate into the resolved lacquer coat.
  • Please note that when treating surfaces with Moisture and Bloom Remover PLUS the lacquer coat will be completely reworked and consequently ‘softened’, so the drying period will be accordingly long.
  • The amount sprayed on is decisive for the solvent reaction. Wait at least 30 minutes to repeat procedure, if necessary.
  • Treated areas will be hard-wearing only when completely
    dried (after 2-3 hours).

Related Products

Share this:

X