Morrells induro® XL2 Floor Lacquer

Preparation

Prior to starting the sanding process the floor should be checked for any protruding nail or screw heads and these should either be removed or countersunk. All wooden floors requiring a varnish will have to be sanded.

Newly laid floors are sanded to achieve a nice level floor and old floors are sanded to remove existing finishes and to level out worn and heavily used areas.

Sanding will have to be carried out in several grit stages and this will be dependent on the unevenness and general condition of the floor.

Staining

Morrells standard Light fast range of stains give excellent grain definition and overall colour. Due to this range being spirit based (fast drying), care should be taken on application not to stain too large an area at once as this could lead to a patchy appearance once the stain is dry.

1. Stain should be applied by brush or rag
2. Remove excesses with a clean rag

It is important to remove as much of excess stain as possible so as not to create a film as this could result in poor adhesion of subsequent coats of lacquer.

Stains intended for other uses i.e. decking, fencing, garden furniture etc should not be considered for floors as these will contain water-repelling properties, and therefore water based floor lacquers would not adhere to these stains.

Application Guidelines

1. apply using a short mohair roller or similar, or mohair flooring pad or t-bar applicator
2. apply lacquer evenly making smooth passes, predominantly along the grain
3. avoid pooling of lacquer

induro® Application Tips

• Denib between coats of induro® XL2
• Avoid equipment containing copper, iron, zinc, aluminium and platinum
• Carry out an adhesion test on a small test area when overcoating non-induro® flooring products
• Use equipment solely nominated for waterborne products only
• Not suitable for pulling over
• Optimum application between 18°C and 22°C with good air movement and ventilation

• Catalysis: 9 parts lacquer : 1 part catalyst by volume
• Pot life: 5 hours
• Touch dry: 20 – 30 minutes @ 18°C
• Recoatable: 2 – 3 hours minimum @ 18°C
• Coats (domestic): 2 – 3 coats
• Coats (commercial): 3 – 4 coats
• Light Use: 24 hours @ 18°C
• Fully Hard: 5 – 7 days @ 18°C
• Traffic: medium – high traffic once fully hard
• Coverage: 40m² per 5 litres dependent upon the size, orientation and surface quality of the item being coated