Rust-Oleum Hard Hat is the number 1 industrial paint aerosol! It contains more pigment and colour than any other paint of it’s type, meaning better colour, better opacity and it’s more long lasting. One Rust-Oleum Hard Hat Topcoat aerosol equals up to 2-3 standard aerosols.
This product produces a higher film build without drips or runs in one go. It has twice the opacity of cheaper paint sprays.This gives a longer gloss and colour retention, the tough and flexible film they create resists chipping, cracking and peeling.
- No drips or runs.
- Excellent hiding power and coverage.
- For use on bare metal, wood and concrete.
- Heat resistant up to 100°C .
- Resists chipping, cracking and peeling.
Surface Preparation
Remove dirt, grease, oil, loose rust and all other surface contaminants by appropriate means.
Prime or spot prime with the recommended RUST-OLEUM Primers. Sand intact coatings to
provide a proper key for adhesion. The surface must be clean and dry during application.
Application Conditions
For good results the relative humidity shall be below 85% and the temperature of the can
above and substrate 0°C.
Â
Application
Remove cover cap. Shake vigorously for at least one minute after the rattle of mixing ball is
heard. Shake frequently during use. Hold can approx. 25 cm from surface. Use back and
forth motion keeping can parallel with surface. Ensure that can is in motion when spray
button is pressed to avoid runs and sags. Apply several thin layers at a few minutes interval
to achieve adequate coating thickness. After use turn can upside down and press spray
button for 2 – 3 seconds to clean valve.