Hawk StandFast Traction Additive

Use StandFast traction additive to apply a slip resistant finish to the surface. This polymer formula offers 100% compatibility between coating and additive. The traction additive particles become an integral part of the cured coating.

Used with Hawk’s Slip Resistance Stencils.

For steel tub application:

• Remove all soap residue using Surface Wash.
• Apply undiluted MicroCleanTM Step I Cleaner evenly over the surface and use either 200 grit sandpaper, or a Scotch Brite Pad to scrub.
• Apply undiluted MicroClean Step II De-Filmer evenly over the surface and use either 200 grit sandpaper, or a Scotch Brite Pad to scrub and remove particulates. Rinse thoroughly with warm water and sponge dry. The surface is pH neutral.
• Apply stencil to surface.
• Mix StandFast Non-Skid Additive – 4 parts resin, 2 parts Catalyst, 3 parts StendFast Traction additive.
• With a 3-inch roller, apply the StandFast mixture to surface and spread evenly.
• Allow solvent to flash. Apply a second coat.
• Cure time depends on the topcoat used.

For fiberglass or previously Resurfaced tubs

• Remove all soap residue using Surface Wash.
• Sand (degloss) area where StandFast Non-Skid Additive will be affixed.
• Follow mix instructions and applications above.
• If using stencils, apply Bonding Agent on fiberglass surfaces. Bonding Agent may not be effective on previously Resurfaced fiberglass surfaces.

StandFast Traction Additive