Enviromose Water Based Stripper

Useful Information

• Wear suitable gloves and eye protection
• Enviromose must be shaken before use
• For best results, use between 10C – 30C degrees
• Do not try to spread the product too far as this will result in poor penetration
• Allow Enviromose to do its work, do not try to remove too quickly
• Never let the surface become to dry

Preperation

• Always test a small area before use
• Ensure surfaces to be stripped are dry
• Protection should be used for floor coatings, or any surfaces that may be damaged by Enviromose

How To Apply

1. Cover top with a cloth during opening to avoid splashes.
2. Apply generous, even coat and do not brush out. Layer Enviromose onto surface to be stripped with suitable brush
3. Leave for 1 hour and apply a second generous coat. For less than 5 layers of paint or varnish, a second coat may not be nececcary.
4. After product has penetrated to the substrate (up to 24 hors) scarpe off, leaving surface as clean as possible.
5. Rub down using a scrubbing brush or stainless steel pad and water.
6. Rinse with clean cold water and allow to dry.