Hawk Repair Blender

Konig Softwax

• Remove all loose and splintered particles and indent damage edges. Use König Touch-Up products to colourdamaged edges that are lighter than the base colour.
• Use the tip of the Special Applicator to take little quantities of the wax stick and fill into the damage area.
• Surplus filler to be planed off with the Special Applicator (use sharp grooves on a flat surface, round grooves at edges).
• Intermediate sealing with Special Repair Lacquer.
• Restore grain with König Touch-Up material. The grain pattern can be restored by slightly scratching (e.g. with an upholstery needle).
• Finally, apply Special Repair Lacquer to seal and to protect the damage area from dust, dirt and to adjust the gloss sheen, if necessary.

Konig Hardwax

• Use the hot tip of the Gas Heat Iron to melt off small quantities of Hard Wax and fill into the damage area.
• Important: Do not set the temperature of the heater too high. Surplus filler to be planed off before wax cools down completely, using the Special Applicator (sharp grooves on a flatsurface, round grooves at edges).
• Surplus wax to be wiped off rapidly with the Scotch Brite using light pressure.
• Restore grain with König Touch-Up material. The grain pattern can be restored by slightly scratching (e.g. with an upholstery needle).
• Finally, apply Special Repair Lacquer to seal and to protect the damage area from dust, dirt and to adjust the gloss sheen, if necessary.