Features & Benefits

• For the glazing dyeing of slight surface damages to furniture and inside furnishings.
• For the coloured preparation and touch-up of surface repairs.
• Recommended for indoor use.
• Dries rapidly.
• Water resistant.
• Good adhesion to varnished and wood surfaces that are free from dust and grease.
• Can be varnished with all König clear lacquers.
• To be refilled with the relevant König Touch-Up Dye 220.

Pack of ten pens available here.

Konig Felt Touch-up Pens

• Remove cap – pen is immediately ready for use.
• Dab on glaze with the tip of the pen as much as required – using no pressure – or apply with short strokes.
• If too much glaze has been applied and therefore the application becomes too dark, it can be toned down with wire wool after it has begun to dry.
• In case of ‘strongly soaking’, untreated or raw wood (e.g. abraded areas) just dab on slightly.
• When repairing filled spots (e.g. with König fillers) apply a barrier coat with Special Repair Lacquer to the ground underneath. To obtain a final sealing, spray again with Special Repair Lacquer.
• From time to time clean the brush tip with a cloth to avoid contamination. Prevent the brush tip coming into contact with lacquers, e.g. when retouching-up lacquers that have not completely dried. The tip might become sticky or resinous.
• Close pen carefully after use – danger of drying up!

Konig Felt Touch Up Dye Pen DATA

Konig Felt Dye Pen Technical