Features & Benefits

• The ceramics filler is very hard and resistant, the melting point is 130 ° C.
• The colors are designed to be mixed together for close colour and pattern matches.
• The water absorption rate is less than 1%.

Can be used on the following

• Drill holes
• Small chips
• Edge damage
• Surfaces and Materials:
• Tiles (Porcelain, Ceramic etc)
• Cast Stone, Terrazzo
• Damaged ObjectsFloor and Wall covering

• Use the hot tip of the Gas Heat Iron to melt off small quantities of Konig Ceramic Filler and fill into the damage area.
• Important: Do not set the temperature of the heater too high. Surplus filler to be planed off before wax cools down completely, using the Special Applicator (sharp grooves on a flatsurface, round grooves at edges).
• Surplus wax to be wiped off rapidly with the Scotch Brite using light pressure.
• Finally, apply Special Repair Lacquer to seal and to protect the damage area from dust, dirt and to adjust the gloss sheen, if necessary.

Konig Ceramic Filler DATA