Konig Softwax is ideal for filling pin holes and damaged edges. Can be used on natural timber or artificial surfaces.

The Hardwax is a durable wax filler, designed for repairs to areas subject to severe use. Ideal for repairing edge damage as well as filling holes and scratches of more significant damage. Applied using our range of battery, gas or electric heating irons.

Also sold as packs of Wax Sticks, see here for more information.

Konig Softwax

• Remove all loose and splintered particles and indent damage edges. Use König Touch-Up products to colourdamaged edges that are lighter than the base colour.
• Use the tip of the Special Applicator to take little quantities of the wax stick and fill into the damage area.
• Surplus filler to be planed off with the Special Applicator (use sharp grooves on a flat surface, round grooves at edges).
• Intermediate sealing with Special Repair Lacquer.
• Restore grain with König Touch-Up material. The grain pattern can be restored by slightly scratching (e.g. with an upholstery needle).
• Finally, apply Special Repair Lacquer to seal and to protect the damage area from dust, dirt and to adjust the gloss sheen, if necessary.

Konig Hardwax

• Use the hot tip of the Gas Heat Iron to melt off small quantities of Hard Wax and fill into the damage area.
• Important: Do not set the temperature of the heater too high. Surplus filler to be planed off before wax cools down completely, using the Special Applicator (sharp grooves on a flatsurface, round grooves at edges).
• Surplus wax to be wiped off rapidly with the Scotch Brite using light pressure.
• Restore grain with König Touch-Up material. The grain pattern can be restored by slightly scratching (e.g. with an upholstery needle).
• Finally, apply Special Repair Lacquer to seal and to protect the damage area from dust, dirt and to adjust the gloss sheen, if necessary.
•  

Konig Hard Wax Technical

Konig Hard Wax DATA

Konig Soft Wax Technical

Konig Soft Wax DATA

Softwax Video

Hardwax Video